Rodents

Bait station securing cable is easy to use and quick to install. Strong, flexible 40cm long marine grade stainless steel cable. Reliably adheres to all clean surfaces with the double sided tape end. Provides outstanding hygiene standards for your clients.

BENEFITS:

• Quicker service, saves time and effort
• Last longer and gives better customer satisfaction
• Very reliable
• Clever, fast way to secure station

This was developed in conjunction with Department of Conservation, and has passed the National Animal Welfare Advisory Committee (NAWAC) guidelines for use as a humane kill trap. Relatively safe and easy to set, these are designed to catch and kill stoats, rats and hedgehogs. For current best practice tunnel designs.

Dimensions:  Height: 182mm Width: 128mm Length: 180mm

Weight: 1500g -  Spring off weight ex factory: < 80g

Clamp pressure: 7Kg approx

Set pressure: 11Kg approx

A specially designed H3 treated wooden
box housing developed to hold rat snap traps. Designed to exclude non-target
species, protect the trap and provide public safety.

A labour and time saving device, it works like a toggle bolt in soil. Duckbills are driven into the ground, providing a safe and environmentally sensitive installation. An upward pull on the anchor tendon rotates the Duckbill into a perpendicular “anchor lock” position in undisturbed soil.

Safer than conventional anchors, Duckbill earth anchors leave no rigid rods, stakes, pipes or stems above ground to injure people or damage equipment. Made of high-impact and shock-resistant Tenaloy aluminum alloy, Duckbills will not rust or corrode.

Heavy duty design using thick walled plastic – Can withstand “stepping on “without any damage to the station. Rotating hinge design provides for years of dependable service without the worries that are found with most stations that use a hinge that is permanently attached to the base

• Low profile design for increased rodent activity.
• High capacity bait chamber.
• Bait placement can be done both horizontally and vertically.
• Single lock design decreases service time
• Can be flush mounted against a wall or structure for maximum effectiveness Recessed cover
• Does not allow for hands or fingers to attempt to pry open station.

For additional security there is a hole in the front of the station that allows you to secure the cover to the base by means of a lock or zip tie. When flush mounted, lid will remain open for easy servicing.

Dimensions : 10.5'' x 10.5'' x 3.4''

The Snap-E Cover is uniquely designed for rodent control in common areas.

• Snap-E Covers keep traps and catch out of sight, keeping children and pets away from rodents and traps
• Paintable
• The Snap-E Cover requires no chemicals and is made of durable plastic construction
• When using Snap-E mousetraps, inspection holes on top of cover makes for faster service
• Each Snap-E Cover includes one safety key

Snap-E® mousetraps are escape proof and the innovative design ensures you'll never touch another mouse. The mechanism is smart, the materials are rugged. Snap-E® mousetraps are easy to use and made to last. Use them year after year. They're safe, simple and sanitary. 

• A sensitive yet powerful mouse kill trap with a bait reservoir
• Plastic and metal construction
• Easy to bait, set and release captured mice

Place the baited SNAP-E near a wall and pull back on the upright bar until it locks firmly in catch. To release, simply pull back on the upright bar until mouse is released. Fingers never touch the mouse. 

A powerful rat trap with a bait reservoir.

• Easy to bait, set and release rat
• Stain resistant, odour free and easy to clean
• Simple, safe and sanitary and built to last
• Made from durable polystyrene and steel

The NoPests®Live Rat cage is a reusable, live-capture rat trapping system. Designed to catch, not kill, meaning no poison, no blood and no injury. Rats are lured into the cage by the bait applied to the hook. The trigger activates when the rat pulls on the bait. The trap door is powered by two powerful springs closing very quickly leaving little chance for rodents to escape. Quick and easy to set, this rat cage is ideal for outdoor use.

The NoPests® Live Rat Cage can also be used to capture other pests such as possums, small stray cats, weasels, rabbits and more. Simply use bait/attractant appropriate to the pest you are trying to catch.

Dimension :33x18x13cm, Wire:2.0mm, Mesh:.54x1.27cm 

Tamper-resistant, single locking mechanism – opens with a key.

Holds up to 4 x 28gm block baits and can accommodate a Trapper T-Rex or Tomcat rat trap.

Tier 1 Rated

Versatile and Efficient Tamper-Resistant Bait Station

PROTECTA EVO Edge is a versatile rodent bait station that is easy to use and service. The station opens and locks quickly with Bell’s EVO key. The built-in service record card holder, side-opening design and rounded interior walls make servicing fast, maximizing technician productivity. The station has a large bait capacity holding up to eight 28 g or four 225 g Blox securely inside the station and comes with vertical securing rods. Protect EVO Edge uses the same replacement bait rods as Protecta Sidekick (SR0667)

Other Features:

• Made from 100% recycled, heavy duty injection-molded plastic
• Bell barcode sticker is pre-installed & ready to use with your tracking software
• Rear mounting holes allow station to be secured to a fence
• Opening on bottom for use with duck bill anchor or used as a drain hole to clear excess water
• Internal service label holder and external service label securing option; service label card can be zip tied to outside of station
• Compact, 8” x 9.5” x 4.5” foot print PROTECTA® EVO® Edge also accommodates two TRAPPER Mini T-Rex mouse snap traps, or a TRAPPER T-Rex rat snap trap, which can be set forward in the runway.

• Technicians can swiftly adjust baiting or trapping tactics at their accounts, without having to switch out their equipment.

Protecta Mouse Bait Station is a mouse-size bait station or a monitoring tool. To capture mice without poison or for mouse identification, place Trapper Mini-Rex Mouse Traps on the studs on the bottom of the Protecta Mouse Bait Station. The studs position the Snap Trap in two locations to capture mice from the side or front.

• They are tamper-resistant, protecting children and non-targeted animals from the poison bait or trap.
• They open with a key (included).
• These stations have four prongs that either holds bait or holds Trapper Mini T Rex Mouse Snap Traps.
• They may be used inside or outside.
• Typical Victor snap traps are too tall for this bait station.
• Use it with non-toxic Detex Blox to monitor mouse activity.
• Mouse entry holes line up with the wall.
• It locks when closed and unlocks with the PROTECTA Sidekick Key 2-prong key.
• Protecta Mouse opens on the side, like a book, making it easy to service when the bait station is flush against a wall.

A re-usable plastic mouse bait station designed to fit flush along edges and into corners of rooms. The bait station is lockable with a key and the interior baffles lead mice to the bait. Designed to hold dry rat baits and mouse baits.

Dimensions: 13cm L x 3cm H x 9.5cm W, holds one Bell Blox.

Single-locking mechanism and side opening lid for fast service. Locking bait rods secure bait and don’t fall out during cleaning. Compact size for versatile station placement and an economic option for tamper resistant bait stations. The SHIELD has a low-profile design constructed from impact-resistant, injection-molded plastic.

• The single-locking mechanism and side-opening lid allow for fast and convenient servicing
• Compact design makes it ideal for tight baiting situations
• Use around the perimeter of buildings and along rodent runways
• Holds 3 x 28g bait BLOX – or soft bait 

An industry standard bait station for possums and rats. The Sentry Bait Station has been used in the possum control industry for over 20 years. It is popular with possum control contractors who want to use cyanide baits or cereal-based pelleted baits.

The Sentry is easily attached to trees or posts using the Sentry and Sentry Plus metal bracket which comes with the bait station. The bait station can be attached either on the left, the right side or the back giving three options for positioning. The Sentry has good weather-proof qualities because it has a hood extending over the feeding hole that protects the bait from rain.

• The design allows the bait station to be stacked which saves space so that more can be carried in a pack.
• Industry standard medium-sized possum and rodent bait station
• One of New Zealand's most popular bait stations for possum and rodent control
• Compact and waterproof design
• Holds 200 g of bait
• Can be efficiently stacked and carried into remote locations
• Translucent in colour with an orange lid allowing them to been seen from a distance.
• Approximately 180 grams in weight.

• Each station is supplied with a bracket.

Dimensions: 155mmL x 100mmW

Diameter of hole = 108mm x 80mm